The installation of the wall tracks is initially the same for the LightLight and Sense System. However, please note the instructions when connecting the Buschfeld light track. On this How it Works page, the installation of the systems is explained in short steps.

Full assembly instructions can be found here >>

Attach wall mounting clips to the wall in an alignment. The mounting height of the tracks depends on the luminaire used
- fasten each wall track with 5 clips
- outer clips max. attach 100 mm from the end of the track and distribute the remaining clips evenly; maximum distance between the clips 500 mm

Tips on mounting height:

Make sure that there is sufficient space for the lights above the mounting height of the wall tracks. This ensures that the directional spotlights can be aligned freely. Some space should also be provided above the wall tracks for the control gear for visible installation.

Press the track onto the clips from above (1.-2.)

 

Installation to be carried out by qualified personnale only! Disconnect the system!

Lighting tracks Sense System or LightLight:
When connecting the infeed and the control gear, the + / - polarity must be observed!
+ Brass inner conductor of the track
- track itself
The polarity is usually also marked with a sticker on the feed.

Installation to be carried out by qualified personnale only! Disconnect the system!

Remove the design housing carefully from the base plate, turn the locking bolts (E) on the side of the adapter to 90°. One adapter has a golden contact pin (B), this adapter must be in contact with the inner conductor of the track.

the control gear is mounted on the track on the rear-side brackets (A); to do this, tilt the base plate up slightly and first place the brackets onto the groove from above (3), then press down firmly against the track (4). Make a supply-side connection (5). 

Replace the control gear housing, pressing all springs (F) together lightly, and push the housing (G) carefully into place.


 

Carefully put on the housing cover, to do this, gently press all springs (L) together and slide the housing (K) on.

Full assembly instructions for Wall48 & Wall Systems can be found here >>



For further informationen / links:
Installation wall tracks
Installation pendant tracks
Installation ceiling tracks
Installation recessed tracks
Buschfeld x Casambi / 1st steps / Create a new network
Not the right topic? – Click here for all you need to know about Buschfeld systems.